Andeli | Emergency Stop Push Button Station 40mm Twist to Release | IP65 Enclosed with 1 N/C Contact
The Andeli SB-BOX is an enclosed emergency stop push button station with a red 40mm mushroom head that latches when pressed and releases on a clockwise twist. The station carries one normally closed contact rated 10A at 440V AC, inside a high-impact IP65 enclosure with pre-scored 20mm cable entries. The SB-BOX measures 69 x 69mm at the base and stands 85mm high with the stop button fitted.
Machinery and portable plant often need a stop within reach of the operator, in a position the switchboard cannot cover. Retrofitting one otherwise means sourcing an enclosure, a mushroom actuator and cable entries separately, then assembling them on the bench. The SB-BOX arrives as a complete enclosed station with the 40mm mushroom and N/C contact already fitted. Pre-scored 20mm entries then accept standard conduit or a gland without drilling the housing.
A stop station that mounts straight out of the box saves the assembly time an equivalent parts list would consume. The SB-BOX suits occasional-use stop positions where a station is required but rarely operated, at a price that keeps a small job viable. The twist to release action prevents an accidental reset, because the head stays latched until somebody deliberately turns it. IP65 protection then covers washdown bays and dusty workshops rather than clean panels alone.
Features
- 40mm mushroom head — a red mushroom actuator that latches down when struck by hand.
- Twist to release — the SB-BOX resets by turning the head clockwise, so pressing it again will not release the stop.
- One normally closed contact — a single N/C contact that opens when the button latches down.
- 10A 440V AC rating — the contact is rated 10A at 440V AC on the published specifications.
- IP65 enclosure — sealed against dust ingress and low-pressure water jets from any direction.
- High-impact housing — supplied in a high-impact enclosure rather than a bare mechanism.
- Pre-scored 20mm entries — cable entries are pre-scored at 20mm for conduit or a gland.
- Complete station — supplied assembled, so no separate actuator, contact block or enclosure is required.
- 69 x 69mm footprint — a compact base that stands 85mm high once the stop button is fitted.
- 149 gram packed weight — light enough to carry several on a service run.
- No published safety standard — compliance with AS/NZS 4024 or ISO 13850 is not published for the SB-BOX, so suitability for a machine safety function needs assessment.
- Single contact only — one N/C contact provides no auxiliary contact and no second channel for a monitored circuit.
Where to use
- Workshop machinery — an accessible stop position beside a bench machine or drill press.
- Pumps and compressors — a local stop where the starter or isolator sits out of reach.
- Conveyors and roller doors — an operator stop positioned at the working point.
- Portable and hire plant — the SB-BOX provides a stop position on trailer-mounted or relocatable equipment.
- Washdown and dusty areas — the IP65 enclosure suits wash bays, food preparation areas and timber shops.
- Agricultural sheds — stop positions on augers, grain handling and general workshop plant.
- Retrofit stop positions — adding a stop to existing plant, with the SB-BOX mounted on the surface near the operator.
Compliance with AS/NZS 4024 or ISO 13850 is not published for the SB-BOX, so it should not be assumed to satisfy a machinery emergency stop function. Where a risk assessment calls for a rated safety component or a monitored contact arrangement, the device for that safety function is determined by the machine designer or a competent engineer. The station carries one normally closed contact and is not rated for immersion, so it suits neither multi-channel safety circuits nor submerged locations.
Verified Sparky Direct customer reviews: Emergency Stop Button 40mm Twist to Release | SB-BOX
"Good entry level stops." — Gary
"This is a sensibly-priced emergency switch from Sparky Direct" — Barrie