Clipsal by Schneider Electric | LED Floodlight 15-20-30W Tri-Colour | Black IP65
The Clipsal CLITPFLT30PSC is a 15W, 20W, or 30W LED floodlight rated IP65 for outdoor and damp locations, with a die-cast aluminium body finished in black. A selector switch on the CLITPFLT30PSC sets both the wattage and the colour temperature across 3000K, 4000K, and 6000K. It runs on 240V mains through a 600mm three-core flex and carries a three-year Clipsal warranty.
Outdoor areas like driveways, yards, and work sheds often need more light than a single fixed-output fitting delivers, but full brightness is not always wanted. A floodlight aimed near a boundary can throw glare toward neighbours, and a high power draw adds up when several lights run at once. The CLITPFLT30PSC answers this with a switchable 15W, 20W, or 30W output and a selectable colour temperature, so one fitting suits security lighting, general visibility, or lower-draw off-grid setups.
For an electrician, one adjustable fitting cuts down the number of stock lines to carry for outdoor jobs. The switch-set wattage and colour selection means the same floodlight covers a security install, a yard light, and a low-draw shed, chosen on site rather than picked from separate stock. The die-cast aluminium body and 110 degree beam give broad coverage from a single point, and the 180 degree adjustable bracket lets the light be aimed once it is mounted.
Features
- Switchable wattage — a selector on the CLITPFLT30PSC sets output to 15W, 20W, or 30W, so brightness and power draw match the task.
- Tri-colour temperature — the same switch selects 3000K warm, 4000K neutral, or 6000K daylight without changing the fitting.
- IP65 rated — sealed against dust and low-pressure water jets, suitable for outdoor walls, eaves, and damp areas.
- Light output — delivers 3150 lumens at 30W, 2100 lumens at 20W, and 1575 lumens at 15W.
- 110 degree beam — a wide spread covers driveways, yards, and open work areas from one mounting point.
- Die-cast aluminium body — a metal housing with a black powder-coat finish and a high-performance aluminium reflector.
- Adjustable bracket — a two-point fastened bracket tilts through 180 degrees to aim the CLITPFLT30PSC after mounting.
- CRI over 80 — colour rendering above 80 shows surfaces and objects in natural tone under the beam.
- 240V mains fitting — wires to 240V supply through a 600mm three-core rubber flex, installed by a licensed electrician.
- 50,000 hour rated life — the LED source is rated to 50,000 hours, reducing replacement cycles on outdoor fittings.
- Not dimmable — output is set by the wattage selector only, and the CLITPFLT30PSC does not work with an external dimmer.
- Not submersible — IP65 covers rain and hose splash but not immersion, so do not install where the fitting sits in water.
Where to use
- Driveways and carports — the CLITPFLT30PSC lights vehicle access and entry points where a wide beam covers the approach.
- Backyards and gardens — the 110 degree spread suits general yard visibility and highlighting trees or garden beds.
- Security lighting — mounted under eaves or on a wall, the floodlight covers entry doors, side passages, and blind corners.
- Sheds and workshops — the lower 15W or 20W setting gives task light in a shed without a heavy power draw.
- Off-grid and solar setups — the 15W setting suits properties running on limited or battery-backed supply.
- Commercial yards and loading areas — the 30W setting on the CLITPFLT30PSC lights parking bays, yards, and storage areas.
- Building sites — fixed or temporary mounting gives broad site light during construction and fit-out.
The CLITPFLT30PSC is not submersible and must not be installed where it sits in standing water or meets high-pressure jets. It is not dimmable and is not intended for enclosed fittings that trap heat around the housing. The floodlight is a 240V mains fitting and must be installed by a licensed electrician.
Verified Sparky Direct customer reviews: Clipsal CLITPFLT30PSC | 15-20-30W Floodlight Black IP65 | Tri Colour 3000K/4000K/6000K (CLITPFLT30PSC)
"Great product, good light performance for pool" — John
"Is great quality, plenty bright enough for the size." — Dane
"Waterproof Security lighting from 15-20-30 Watt's at a flick of a switch" — Chris
