4Site | Nylon Cable Tie 100mm x 2.5mm 100 Pack | Black
The 4Site CT100B is a black nylon cable tie measuring 100mm long and 2.5mm wide, supplied in a pack of 100. The tie is a moulded one-piece design with an internal pawl that grips the toothed strap for one-way tensioning. The CT100B is a light-duty size, suited to small bundles of thin cable, flex, and hook-up wire.
Unsecured cable and loose flex create clutter inside enclosures, along cable trays, and behind equipment racks. A 100mm tie suits small-diameter groupings, where a longer tie leaves an awkward tail requiring removal. The 2.5mm width negotiates tight gaps between fixed conductors and framing without forcing the grouping apart. Bundling thin conductors during installation keeps the run organised and simplifies later fault-finding.
The CT100B tensions by hand, so a full run installs quickly without a separate tensioning tool. The 100-pack maintains a working supply in the van or on the bench for repeated cable management across a job. At this dimension the ties suit data, alarm, and lighting flex rather than heavier mains bundles. Purchasing cable ties in bulk keeps the consumable cost per installation low on high-volume fit-offs.
Features
- Black nylon construction — the moulded one-piece nylon body gives the CT100B consistent grip across repeated fastening tasks.
- 100mm x 2.5mm size — a compact tie sized for small groups of thin cable, flex, and hook-up wire.
- Internal pawl ratchet — the toothed strap locks one way against an internal pawl, holding tension once pulled up.
- Hand-applied, no tools — feed the tail, pull, and the tie self-locks, so a run goes on without a tensioning tool.
- 100-pack supply — a bulk count that keeps a working stock of the CT100B in the van or on the bench.
- Light-duty size — suited to small-diameter groups of thin cable, not large bundles or heavy strain loads.
- Low-profile head — the small head keeps grouped cable tidy in shallow gaps and behind flush plates.
- Trimmable tail — the excess strap cuts flush with side cutters for a clean finish on a visible run.
- General cable management — the CT100B groups data, alarm, lighting flex, and loose conductors inside enclosures and cavities.
- Permanent once seated — the tie holds closed under tension and is removed by cutting the strap, not by release.
- Consistent bulk pack — uniform ties across the 100-pack keep fit-off speed steady on high-volume work.
Where to use
- Enclosure and switchboard tidy-ups — the CT100B groups thin control and signal wiring inside boards and cabinets.
- Data and comms runs — bundles patch leads, alarm cable, and low-voltage flex behind racks and outlets.
- Lighting and flex dressing — gathers pendant flex and fixture tails for a neat finish at the rose or fitting.
- Workshop and bench work — the CT100B keeps hook-up wire and test leads grouped during assembly and repair.
- Home, garage, and DIY jobs — handles light cable management for AV, networking, and appliance leads.
- Securing small components — holds loose parts, tags, and thin looms in place during a fit-off.
The CT100B is a light-duty tie and is not suited to large-diameter bundles or heavy strain loads. It is intended for general indoor and protected cable management, so confirm suitability before any outdoor or UV-exposed installation. Match the tie length to the bundle so the strap seats fully through the head and holds tension.
