4Site | Nylon Cable Tie 150mm x 3.6mm 100 Pack | Black
The 4Site CT150B is a black nylon cable tie measuring 150mm long and 3.6mm wide, supplied in a pack of 100. The tie is a moulded one-piece design with an internal pawl that grips the toothed strap for one-way tensioning. The CT150B is a general-purpose size, holding medium cable bundles, looms, and grouped conductors.
Unsecured cable and loose looms drift out of position inside enclosures, along tray runs, and behind mounted equipment, creating clutter that complicates later work. A 150mm tie closes around medium bundles that a smaller tie cannot manage cleanly. The wider 3.6mm strap distributes holding tension across the group rather than concentrating it at a single point. Bundling conductors during installation keeps the run organised and simplifies later inspection and fault-finding.
The CT150B tensions by hand, so a full run installs quickly without a separate tensioning tool. The 100-pack maintains a working supply in the van or on the bench for repeated cable management across a job. At 150mm the ties suit general electrical, data, and automotive looms rather than the smallest flex groups. Purchasing cable ties in bulk keeps the consumable cost per installation low on high-volume work.
Features
- Black nylon construction — the moulded one-piece nylon body gives the CT150B consistent grip across repeated fastening tasks.
- 150mm x 3.6mm size — a general-purpose tie for medium cable bundles, looms, and grouped conductors.
- Internal pawl ratchet — the toothed strap locks one way against an internal pawl, holding tension once pulled up.
- Hand-applied, no tools — feed the tail, pull, and the tie self-locks, so a run goes on without a tensioning tool.
- 100-pack supply — a bulk count that keeps a working stock of the CT150B in the van or on the bench.
- Medium-duty size — suited to general and medium bundles, not the largest groups or heavy structural strain.
- Wider 3.6mm strap — spreads holding tension across the bundle and gives more contact than a thin 2.5mm tie.
- Trimmable tail — the excess strap cuts flush with side cutters for a clean finish on a visible run.
- General cable management — the CT150B groups electrical, data, automotive, and appliance wiring inside enclosures and cavities.
- Permanent once seated — the tie holds closed under tension and is removed by cutting the strap, not by release.
- Consistent bulk pack — uniform ties across the 100-pack keep fit-off speed steady on high-volume work.
Where to use
- Enclosure and switchboard bundling — the CT150B groups control, power, and signal wiring inside boards and cabinets.
- Data and comms looms — gathers patch leads, alarm cable, and low-voltage flex behind racks and outlets.
- Lighting and flex dressing — bundles pendant flex and fixture tails for a neat finish at the rose or fitting.
- Automotive and vehicle wiring — the CT150B holds looms and accessory leads during fit-out and repair.
- Workshop and trade setups — keeps hook-up wire, hose, and test leads grouped on the bench.
- Home and DIY cable management — tidies AV, networking, and appliance leads around the house.
The CT150B is a medium-duty tie and is not suited to very large bundles or heavy structural strain. It is intended for general indoor and protected cable management, so confirm suitability before any outdoor or UV-exposed installation. Match the tie length to the bundle so the strap seats fully through the head and holds tension.
