4Site | Nylon Cable Tie 200mm x 4.8mm 100 Pack | Black
The 4Site CT200B is a black nylon cable tie measuring 200mm long and 4.8mm wide, supplied in a pack of 100. The tie is a moulded one-piece design with an internal pawl that grips the toothed strap for one-way tensioning. The CT200B is a medium to heavy-duty size, holding larger cable bundles, hoses, and grouped conductors.
Larger cable runs and bundled hoses drift out of position when nothing secures them along a tray or behind a panel, producing a disorganised install. A 200mm tie encloses bigger bundles that a shorter tie cannot reach around cleanly. The wide 4.8mm strap distributes greater holding tension across the group, which suits heavier looms and equipment leads. Grouping conductors during installation keeps the run organised and simplifies later inspection and fault-finding.
The CT200B tensions by hand, so a full run installs quickly without a separate tensioning tool. The 100-pack maintains a working supply in the van or on the bench for repeated cable management across a job. At 200mm the ties suit larger electrical, automotive, and equipment looms rather than thin flex groups. Purchasing cable ties in bulk keeps the consumable cost per installation low on high-volume work.
Features
- Black nylon construction — the moulded one-piece nylon body gives the CT200B consistent grip across repeated fastening tasks.
- 200mm x 4.8mm size — a medium to heavy-duty tie for larger cable bundles, hoses, and grouped conductors.
- Internal pawl ratchet — the toothed strap locks one way against an internal pawl, holding tension once pulled up.
- Hand-applied, no tools — feed the tail, pull, and the tie self-locks, so a run goes on without a tensioning tool.
- 100-pack supply — a bulk count that keeps a working stock of the CT200B in the van or on the bench.
- Medium to heavy-duty size — suited to larger bundles and looms, not structural strain that needs a load-rated tie.
- Wide 4.8mm strap — carries more holding tension and gives more contact across the bundle than a narrow tie.
- Trimmable tail — the excess strap cuts flush with side cutters for a clean finish on a visible run.
- General cable and equipment management — the CT200B groups electrical, automotive, and equipment wiring inside enclosures and cavities.
- Permanent once seated — the tie holds closed under tension and is removed by cutting the strap, not by release.
- Consistent bulk pack — uniform ties across the 100-pack keep fit-off speed steady on high-volume work.
Where to use
- Larger enclosure and tray bundling — the CT200B groups heavier power, control, and signal wiring inside boards and cabinets.
- Automotive and machinery wiring — the CT200B holds looms, harnesses, and accessory leads during fit-out and repair.
- Equipment and hose fastening — secures grouped hose, conduit, and leads on plant and machinery.
- Data and comms trunk runs — bundles thicker cable groups behind racks, cabinets, and outlets.
- Workshop and trade setups — keeps hook-up wire, hose, and test leads grouped on the bench.
- Home and DIY heavier cable jobs — tidies AV, networking, and appliance leads where a small tie will not reach.
The CT200B is a medium to heavy-duty tie and is not a load-rated fixing for structural or safety-critical loads. It is intended for general indoor and protected cable management, so confirm suitability before any outdoor or UV-exposed installation. Match the tie length to the bundle so the strap seats fully through the head and holds tension.
